ir quartz heating tube 508mm 1500w halogen lamp

July 16, 2026

Let’s talk about the 508mm 1500W Halogen IR Quartz Tube

If you’re looking for a heater that doesn’t mess around, this is it. We built these 508mm quartz lamps to pump out high-intensity short-wave infrared radiation. At 1500W, the heat is concentrated right where you need it. It’s fast. Really fast. You aren’t waiting around for a slow ramp-up here; it hits peak temperature almost the second you flip the switch. Getting the power right The 508mm length gives you a very specific heating footprint. We’ve dialed the wattage to 1500W so you get enough flux to actually penetrate your materials without melting the quartz envelope itself. But here’s the thing: you’ve got to match your power supply to the lamp’s voltage. If you over-volt it, you’re basically asking the filament to burn out early. Keep it steady, and the lamp stays happy. The secret sauce: Halogen and Quartz We use a halogen gas fill to keep things running. Basically, as the tungsten filament evaporates, the gas pushes that tungsten right back to the center of the wire. It stops the filament from thinning out and giving up the ghost too soon. Then there’s the quartz glass. We use it because it can handle insane heat and lets those IR waves pass through without any trouble. You’ll usually see these as drop-in replacements for things like PET blowing machines or industrial curing ovens. Just a heads-up: because these get so hot, make sure your seals and connectors are tight. Loose wiring is a recipe for arcing at the terminals, and nobody wants that. A few things to watch out for This lamp puts out a massive amount of heat. That’s great for speeding up your production, but it’s a lot for your cooling fans to handle. If your airflow isn’t up to the task, that heat is going to soak back into the housing and fry your wiring. It’s worth double-checking your thermal shielding before you wire everything up. And one last tip? Use a dedicated PID controller. If the lamp is constantly clicking on and off, it puts a lot of mechanical stress on the filament. A controller keeps things smooth.